I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it
was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and
LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the
bootloader and stock firmware will accept.
The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving
its LEDs through an HC164 8-bit shift register.
Signed-off-by: Owen Kirby <osk@exegin.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36482 3c298f89-4303-0410-b956-a3cf2f4a3e73
Hardcoding channel number to 11 is a bad idea, it may be even not
available on some devices. If there are two single-band radios, the
one for 5GHz doesn't have 11 channel.
Signed-off-by: Rafał Miłecki <zajec5@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36479 3c298f89-4303-0410-b956-a3cf2f4a3e73
To add support for core rev 28 there are a lot more changes needed.
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36477 3c298f89-4303-0410-b956-a3cf2f4a3e73
This fixes working behind another router which gives out ULAs.
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36416 3c298f89-4303-0410-b956-a3cf2f4a3e73
It's needed for dealing with certain UART-to-USB adapters built into
e.g. weather stations, and increases the hid module package only
slightly (e.g. on ar71xx: 35k -> 37k).
Signed-off-by: Danny Baumann <dannybaumann@web.de>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36415 3c298f89-4303-0410-b956-a3cf2f4a3e73
Needed to support e.g. keyboards and mice.
Signed-off-by: Danny Baumann <dannybaumann@web.de>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36414 3c298f89-4303-0410-b956-a3cf2f4a3e73
Package up the Microchip MCP23S08 I/O expander driver. Needed on the
CalAmp LMU5000 board.
Signed-off-by: Adam Porter <porter.adam@gmail.com>
[jogo@openwrt.org: fix subject]
Signed-off-by: Jonas Gorski <jogo@openwrt.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36393 3c298f89-4303-0410-b956-a3cf2f4a3e73
* Add preliminary support for RFC 6603 prefix exclusion
* Fix reconfigure-support and reconfigure authentication
* Set maximum retransmission timeout for solicitations to 2h
* Fix a segfault when parsing IA_PD in advertise messages
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36382 3c298f89-4303-0410-b956-a3cf2f4a3e73
- fixes memory leak in libuci when trying to open not existing configurations
- fixes memory leak in libuci-lua when querying not existing sections or options
- fixes handling of filenames with leading underscore
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36377 3c298f89-4303-0410-b956-a3cf2f4a3e73
If the first byte is available in the address mask, use only that one -
set the local bit and xor it with the id << 2. This ensures that there
are no hardware BSSID & BSSID-mask conflicts with devices that have
almost the same MAC address with just a small offset. The MAC address
conflict has been observed in a deployment with some devices from the
same batch when running with multiple interfaces.
If only some bits of the last byte are available, xor the id onto the
last MAC address byte (relevant mostly for Ralink devices).
In other cases (should not happen at this point), use the previous MAC
address offset calculation but without the local bit.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36353 3c298f89-4303-0410-b956-a3cf2f4a3e73
make the syntax more compatible with kernel menuconfig
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36351 3c298f89-4303-0410-b956-a3cf2f4a3e73
