diff --git a/hdk/getting_started.md b/hdk/getting_started.md
index 8dd7f7f..2697c90 100644
--- a/hdk/getting_started.md
+++ b/hdk/getting_started.md
@@ -2,19 +2,19 @@
 
 ## Things you will need
 
-1) The HDK
-2) A Wifi Pineapple
-3) A Soldering iron
-4) A programmer (an arduino is fine)
-5) (optionally) a USB to serial converter.
+1. The HDK
+2. A Wifi Pineapple
+3. A Soldering iron
+4. A programmer (an arduino is fine)
+5. (optionally) a USB to serial converter.
 
-![](imgs/hdk1.png)
+![The HDK as it arrives](imgs/hdk1.png)
 
 ## Set up of the HDK in the Pineapple
 
 The HDK talks to the Wifi pineapple via a bit-banged SPI interface, using on board gpios. These are not enabled by default. In order to enable the interface, type:
 
-/sbin/insmod spi-gpio-custom bus0=1,18,20,19,0,125000,21
+`/sbin/insmod spi-gpio-custom bus0=1,18,20,19,0,125000,21`
 
 Once this command has been run, a new device /dev/spidev1.0 will be created. 
 
@@ -22,9 +22,14 @@ Once this command has been run, a new device /dev/spidev1.0 will be created.
 
 ![](imgs/hdk2.png)
 
+![](imgs/hdk3.png)
+
+![](imgs/hdk4.png)
+
+
 ## Programming the HDK
 
-![](imgs/hdk3.png)
+![](imgs/hdk5.png)
 
 ### Example program